Turning On Lasers Manually; To Turn On Lasers - Agilent Technologies SureScan G4900DA User Manual

Turning on Lasers Manually

The lasers are turned on automatically when you start the Scan Control program, or when you add
slides to the queue. They turn off automatically, based on the Laser Saver Delay settings. See
set the laser saver delay"
NOT E

To turn on lasers

• In the Scan Control program window, click Tools > Switch on Lasers.
The lasers are turned on. The Status Log displays "Warming up lasers" and the status bar
displays "Warming up."
When the lasers are warmed up, the status bar displays "Ready."
SureScan System User Guide
on page 46. This section describes how to turn on the lasers manually.
Once the lasers are turned on, it takes up to 5 minutes for them to warm up
before the instrument is ready to scan
"To
43