Presetting; Other Settings - Panasonic SC-HT400K Operating Instructions Manual

Presetting

TUNING
2 1
POWER
8
SPEAKERS - HELP - BAND
– RESET – FM MODE MEMORY
TUNING
2 1
PHONES
PRESET
Automatic presetting
- BAND
1 1 Press [
– FM MODE ] to select "FM".
TUNING
2 2 Press [
] to tune to "FM 87.9 MHz".
2 1
3 3 Press and hold [
The FM stations the unit can receive are preset in channels 1 to 30.
- BAND
4 4 Press [
– FM MODE
] to select "AM".
TUNING
5 5 Press [
] to tune to "AM 530 kHz".
2 1
6 6 Press and hold [
The AM stations the unit can receive are preset in channels 21 to 30.
(FM stations are replaced if any were preset in these channels.)
During automatic presetting, the memory indicator (˜) flashes and
the frequency scrolls. The memory indicator and channel numbers
are displayed for a second when a station is preset.
The last station to be preset is displayed when presetting finishes.
Manual presetting
Preset the stations one at a time.
1 1 Tune to the station.
2 2 Press [
MEMORY
].
TUNING
3 3 Press [
] to select a channel.
2 1
4 4 Press [
MEMORY
].
Selecting channels
1 1 Press [
].
PRESET
The channel number flashes for about 5 seconds.
TUNING
2 2 Press [
].
2 1
Hold down the buttons to change channels faster.
For your reference
Even if the power supply cord is disconnected from the household
AC outlet, the stations remain in memory for approximately one
month.
Improving reception
¡ DSP DEFEAT
DSP
SOUND MODE
Press and hold [
DSP
SOUND MODE
Press and hold [
Note
While the DSP is defeated, you cannot:
– Select DSP sound modes,
– Adjust the tone,
– Output a test signal,
– Adjust individual speaker output, or
– Use digital input.
¡For your reference
DVD players can interfere with radio reception. Turn the DVD
14
player off or move it further away from the antennas if this occurs.
RQT6361
- BAND MEMORY
– FM MODE
VOLUME
INPUT SELECTOR
w q
SFC MODE
DOWN UP
TAPE MONITOR SUBWOOFER
DSP DOLBY
SOUND MODE PRO LOGIC 2 BASS/TREBLE
PRESET
BALANCE
DSP
SOUND MODE
MEMORY
].
MEMORY
].
] until "DEFEAT" appears.
] again to turn the DSP on.

Other settings

w
DIGITAL INPUT
POWER
DVD 6CH INPUT
8
3 4
L R
SPEAKERS
PHONES
DR COMP –
Dynamic range compression
Change this setting to listen to software recorded with Dolby Digital
at low volume (such as late at night) and maintain audio clarity. It
reduces the peak level in loud scenes without affecting the sound
field.
OFF: The software is played with the original dynamic range
(factory setting).
STANDARD: The level recommended by the producer of the
MAX: The maximum allowable compression (recommended for
night viewing).
1 1 Press [
the setting mode.
2 2 Press [
3 3 Turn [
"MAX".
4 4 Press [
the setting mode.
DIMMER –
Dim the unit's display for better viewing in a
darkened room
The factory setting is OFF (normal brightness).
1 1 Press [
the setting mode.
2 2 Press [
3 3 Turn [
4 4 Press [
the setting mode.
q
SFC MODE
VOLUME
w q
SFC MODE
DOWN UP
- HELP - BAND
– RESET – FM MODE MEMORY
DSP DOLBY
TUNING SOUND MODE PRO LOGIC 2
2 1 PRESET
software for household viewing.
] at the same time to enter
w q
SFC MODE
] to select "DR-COMP".
w q
SFC MODE
INPUT SELECTOR
] to select "OFF", "STANDARD" or
] at the same time to exit
w q
SFC MODE
] at the same time to enter
w q
SFC MODE
] to select "DIMMER".
w q
SFC MODE
INPUT SELECTOR
] to select "OFF" or "ON".
] at the same time to exit
w q
SFC MODE
INPUT SELECTOR
INPUT SELECTOR
DIGITAL INPUT
TAPE MONITOR SUBWOOFER DVD 6CH INPUT
BASS/TREBLE 3 4
BALANCE L R