Installation Instructions; Tap Installation - Zenith ChillTap Residential Installation Instructions & User Manual

Blue and Red
tubes to Tee piece
which connects
to Vent Outlet.
White tube to
Chilled Outlet
Fig.1 ChillTap Standard / Heavy Duty
O-RING
WASHER
Blue tube to
Chilled Outlet
White tube
to Ambient
Outlet
Fig.2 ChillTap Extra

Installation instructions

Tap installation

In addition to common tools, the following will be required:
• 25mm (ChillTap Standard/Heavy Duty) OR 35mm (ChillTap
O-RING
NUT
• 25mm (ChillTap Standard/Heavy Duty) OR 35mm (ChillTap
Position the Tap
Position and install the tap at the back of the sink or on the Font,
where there is a minimum 52 mm wide flat area within the draining
area of the sink. Make sure the selected position allows the tap
spout to overhang the sink bowl.
Ensure the distance between the tap and the command centre
does not exceed the length of the supplied tubing.
ChillTap Standard/Heavy Duty (Fig.1)
Use a 25mm sheet metal punch or hole saw to create a neat hole
without burrs.
Remove the large nut from the base of the tap, leaving the rubber
sealing ring (O-ring) in place.
LOWER
Fit the tap and O-ring to the sink top, oriented so the operating
RUBBER
WASHER
lever is easily accessible.
From under the sink, slide the nut over the tubes. Tighten the nut
NUT
to secure the tap firmly into place.
ChillTap Extra (Fig.2)
Use a 35mm sheet metal punch or hole saw to create a neat hole
without burrs.
Red tube to
Vent Outlet
Remove the large nut with the stainless steel and rubber washers
from the base of the tap, leaving the rubber sealing ring (O-ring) in
place.
Fit the tap and O-ring to the sink top, oriented so the operating
levers are easily accessible.
From under the sink, slide first the rubber washer, and then the
brass washer, followed by the nut, over the tubes. Tighten the nut
to secure the tap firmly into place.
Extra) diameter sheet metal hole punch for sink tops (not
supplied)
Extra) diameter hole saw for timber bench tops (not
supplied)
Warning: Do not reuse old hose-sets. The unit shall be
installed with the new hose-sets supplied. Hoses are
maximum 1000 mm in length.
806143NZ v1.06 07.19 CW ChillTap UCCT
05