Connecting Other Video Equipment - Panasonic DMR-HS2 Operating Instructions Manual

Home Theater

Connecting other video equipment

Connecting to the L2 input terminals on the front of
the unit [A]
/ I
POWER
S video cable
Audio/Video
cable (included)
S VIDEO
OUT
Other video equipment
Connect to the video and audio output terminals.
§
By using the S video cable instead of the yellow video cable you
may make recordings of higher picture quality.
[Note]
≥If the audio output of the other equipment is monaural, connect to
L/MONO. (Both left and right channels are recorded when
connected through L/MONO.)
≥The DV input on this unit is for use with DV equipment only.
≥When DV equipment is connected, it is not possible to operate the
unit from the other equipment.
≥Only one piece of DV equipment (e.g., Digital Video Camera) can
be connected to the unit via the DV Input terminal.
≥The picture compression system of the DV equipment you have
connected may differ from that used in this unit. In such cases,
dubbing from these equipments will not be possible.
58
RQT6570
yellow white red
§
i.LINK
cable
(IEEE
1394)
yellow white red
L R
VIDEO
DV
AUDIO
OUT
OUT
OUT
Connecting to the input terminals on the rear of the
unit, L1 and L3 [B]
R - AUDIO - L VIDEO
OPTICAL
DIGITAL AUDIO OUT
R - AUDIO - L VIDEO
(PCM/BIT STREAM)
red white yellow
Audio/Video cable
(included)
red white yellow
R L
AUDIO VIDEO
OUT OUT
Other video equipment
Connect to the video and audio output terminals.
§
By using the S video cable instead of the yellow video cable you
may make recordings of higher picture quality.
[Note]
If audio output on the other equipment is monaural, use a stereo-
monaural conversion cable (not included).
!?
(L1)
S-VIDEO R - AUDIO - L
S-VIDEO R - AUDIO - L
(L3)
§
S video cable
S VIDEO
OUT