HP 82718A Expansion Pod Reference Manual page 10

'eI
m
i,
,
t
J
,
7) Set the HP 82718A right-side up so its nameplate is facing
you. The area marked # 1 in the photo is the battery box,
and #2 is the ROM connector.
8) Place the carrying clips as shown. Notice that they are both
oriented in the same direction. If you do not plan to use the
clips, you do not have to install them, or you can place them
one rib farther back, and they will be fully concealed by the
retainers that hold the HP -75 to the HP S 2 71 SA.
9) Plug the HP S2718A ROM connector securely into the
right-most port on the HP-75. Then set the HP-75 down
onto the battery box. The tab protruding from the bottom of
the ROM connector slips inside the slot on the HP S 271 SA
housing.
10) Holding the HP-75 securely to the HP S 271 SA, attach the
two plastic retainers to the unit by screwing in the six long
screws provided into the six holes on the bottom of the
HP S 2 71 SA. Be sure the carrying clips align with the
notches on the retainers.
Your HP 8271SA Expansion Pod is now ready for use.
In trod uction
.
.
• . '1::
;
~~:::;
2,;;
~
:
.
~
9