Cisco Firepower 4100 Series Manual page 16

1-Gb SX/10-Gb SR/10-Gb LR Network Module with Hardware Bypass
Note Make sure you have the correct firmware package and software version installed to support this network
module. For instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the
FXOS Compatibility
Figure 12: FPR4K-NM-6X1SX-F, FPR4K-NM-6X10SR-F, FPR4K-NM-6X10LR-F
1 Captive screw/handle
3 Bypass LEDs B1 through B3:
• Green—In standby mode.
• Amber, flashing—Port is in hardware bypass
• Amber—Port is in hardware bypass mode,
Ethernet X/3 (top port)
5
Ethernet X/4 (bottom port)
Ports 3 and 4 are paired together to form a
hardware bypass pair.
The 1-Gb SX /10-Gb SR/10-Gb LR network modules have the following insertion loss measurements. Insertion
loss measurements help you to troubleshoot the network by verifying cable installation and performance.
Overview
16
Cisco Firepower 4100/9300 FXOS Firmware Upgrade
for the software compatibility matrix.
mode, failure event.
forced.
Guide. See Cisco Firepower 4100/9300
2 Six network activity LEDs
• Amber—No connection, or port is not in use,
or no link or network failure.
• Green—Link up, no network activity.
• Green, flashing—Network activity.
4 Ethernet X/1 (top port)
Ethernet X/2 (bottom port)
Ports 1 and 2 are paired together to form a
hardware bypass pair.
Ethernet X/5 (top port)
6
Ethernet X/6 (bottom port)
Ports 5 and 6 are paired together to form a
hardware bypass pair.
Overview