Cisco Firepower 4100 Series Manual page 13

Overview
1-Gb Network Module with Hardware Bypass
The following figure shows the front panel view of the 1-Gb network module with hardware bypass
(FPR4K-NM-8X1G-F). Pair ports 1 and 2, 3 and 4, 5 and 6, and 7 and 8 to form hardware bypass paired sets.
Note
Make sure you have the correct firmware package and software version installed to support this network
module. For instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the
FXOS Compatibility
Figure 10: FPR-NM-8X1G-F
1
3
5
Cisco Firepower 4100/9300 FXOS Firmware Upgrade
for the software compatibility matrix.
Captive screw/handle
Ethernet X/1
Ports 1 and 2 are paired together to form a
hardware bypass pair. LED B1 applies to this
paired port.
Ethernet X/2
Ports 5 and 6 are paired together to form a
hardware bypass pair. LED B3 applies to this
paired port.
1-Gb Network Module with Hardware Bypass
Guide. See Cisco Firepower 4100/9300
2 8 network activity LEDs
• Left LED—Green indicates network activity
when a 10M/100M/1G connection is made.
• Right LED—Not in use at this time.
4 Ethernet X/2
Ports 3 and 4 are paired together to form a
hardware bypass pair. LED B2 applies to this
paired port.
Ethernet X/2
6
Ports 7 and 8 are paired together to form a
hardware bypass pair. LED B4 applies to this
paired port.
Overview
13