Video Drivers; Cctv Components - Siemens DMS8000 MP4.30 Connectivity Manual

Configuring CCTV network
2.2.1

Video Drivers

2.3

CCTV components

Building Technologies
Fire Safety & Security Products
The VNM can support the drivers required to handle the network communication
with:

TELSCAN video web server

SISTORE video digital recorders
Note: SIMATRIX units do not need any Video driver.
Depending on the specific configuration required, add one or both drivers to your
project. Proceed as follows:
1. Select the VNM node.
2. In the toolbar, click the icon corresponding to the driver you need (Fig 3):
A – Siemens TELSCAN
B – Siemens SISTORE
Fig 3 Video drivers
A Select this icon to add the TELSCAN driver
B Select this icon to add the SISTORE driver
In small system, the Video Driver is installed on the MM8000 server. Large sys-
tems may include FEP stations with additional Video Drivers that can distribute the
traffic load.
In general, each driver can support video several video connections (at least 40).
Please refer to the MM8000 datasheet and release notes for getting the most recent
recommendations and limits concerning the driver load for each video device.
If the VNM is not present, the Video Folder
the following two icons:

SIMATRIX switching crossbar

Burle
If the VNM is present, the Video Folder
additional set of icons, corresponding to the following CCTV components:

Video Cameras

Video Monitors

TELSCAN WEB Server

IP Cameras supporting TELSCAN LAN protocol
048_DMS_DMS8000_Connectivity_Video_MP4.30_A6V10062457_a_en.doc
on the left hand side includes only
on the left hand side includes also an
7
06.2010