2.4
Camera configuration
2.4.1
Configuration checklist
2.4.2
Configuration procedure
10
Building Technologies
Fire Safety & Security Products
Verify that you have satisfied the items needed in the first checklist before proceed-
ing to the configuration procedure that follows.
ITEMS NEEDED FOR CONFIGURATION
The number, names, and type of cameras: fixed, Dome, or PTZ.
The application type in relation to the video recording: Manual or Automatic.
If the camera is used for motion detection applications or is somehow not meant for
the direct control of the operators, set Automatic mode.
The cameras connection to SIMATRIX, SISTORE, and TELSCAN.
Plug-ins needed:
Plug-in #352801, which must be installed before you can configure your system.
–
The following are the configuration procedures for the video cameras.
Adding the Video Network Manager
1. Open the Composer project.
2. If not already done, add the Video Network Manager ( 2.2 at p.5).
Adding the folder for cameras
1. In the left-hand bar, select the Video folder icon
2. In the menu that appears, select the Video Camera folder icon
folder ( Fig 4 at p.8).
Adding a video camera
1. Select the Video Cameras folder.
2. In the left-hand bar (Fig 6), select the type:
– Fixed camera
– PTZ camera
– Dome camera
Also, in the same menu you can add additional folders that let you better organ-
ise the camera units according to type, location, etc.
048_DMS_DMS8000_Connectivity_Video_MP4.30_A6V10062457_a_en.doc
Configuring CCTV network
to add a
06.2010