Controls - Hobart AMXXT Series Installation & Operation Manual

4

Controls

➀
Machine ON / OFF
(illuminates during operation)
➁
Start button
➂
Drain button
(illuminates during operation)
➃
Program button
➄
Temperature indicator Wash (°C)
➅
Temperature indicator Rinse (°C)
➆
Salt required
➇
Service indicator
8
3 1
By pushing this button the machine will be switched on.
In case of emergency (e.g. faults), it is possible to switch off
the machine immediately without drain cycle, by pushing this
button again.
After switch off, the machine is not voltage free!
This button illuminates to indicate the mode of the machine:
RED = machine fills and starts heating
GREEN = machine is ready for operation
BLUE = selected program is running
AUXXT models only: High pressure cleaning
Never use for cleaning glasses and light dishes
(breakage) !
High pressure mode for a running cycle will be activated by
short pushing the blue illuminated Start button (not possible
within the first 5 seconds after cycle start).
By pushing and holding (3 sec.) the Start button, high
pressure mode will be activated permanently.
By pushing and holding (2 sec.) this button, the drain and
self cleaning cycle starts. At the end of the cycle, the
machine switches off automatically.
After switch off, the machine is not voltage free!
By pushing this button, it is possible to select between
different pre-set programs, according to the model and
equipment. The program no. (e.g. P02) appears at the rinse
➅
temperature indicator
Indicates only on demand (see chapter 8).
Indicates only on demand (see chapter 8).
Indicating the need for regeneration salt to be added.
(Only with built-in softener.)
Indicating, that the machine has a fault.
8
7 4 2
.
6
5