Panasonic FZ-G1 Series Supplementary Instructions Manual page 5

CAUTION
l Attach the Velcro straps securely. Otherwise, the computer may fall off.
l If the hand strap loosens, the computer may fall down.
l Do not use the strap if it becomes worn or damaged.
l Before using, check if the mounting clips and the screws have been firmly fixed.
NOTE
l The supplied digitizer pen can be stored in the leather case as illustrated on the
right.
n When Cleaning inside of the dust cover
A Remove the edge of hand strap passing through the clip.
B Tip the clip back to pull it out of the computer.
C Open up the whole hand strap.
n When Disposing of the computer
A Open the hand strap by following the steps A - C in "When Cleaning inside
of the dust cover".
B Remove the 4 screws fixed to the board using a Phillips head screwdriver
and remove the board.
C Remove the battery pack.
n Using the hand strap
A When using the computer holding with hand, insert your hand to (A) part of
the hand strap.
B Fix the hand strap firmly so that the computer does not come off, and then
turn it over.
CAUTION
l If the hand is not securely fixed to the hand strap, the computer may drop.
n Adjusting the hand strap
When the hand strap is too loose or too tight, you can adjust the hand strap according to the instructions below.
A Remove (A) from the strap joint and next remove (B).
B Adjust the position (C) and put (B) and (A) back in place.
n Removing the leather case from the computer
Perform the steps in the reverse order.
Ÿ Before removing the leather case, always make sure you close the DC-IN Jack cover. Failing to close the DC-IN Jack
cover when removing the case may cause damage to the leather case and cover.
5