Dumping - Roadtrek CS Adventurous 2019 Owner's Manual

Dumping

The macerator dump hose, along with the grey and black tank gate valves, are located under the first set of running boards on the driver's side of
the coach. (Picture 53.1)
*Note – The macerator hose is approximately 1½ " in diameter. A 4" rubber adapter is included in your coach's accessory box. Place
this adapter on the hose end to fit the standard 4" hose dump locations.*
The macerator dump 12-Volt power button is located on the driver's seat base. (Picture 53.2) *Note – 12-Volt battery disconnect must be in the
On position for macerator to operate.*
Pull out the macerator hose and place in dump facility. Open the flow valve on the hose neck to allow for the flow of tank contents. See open
position in picture 53.1.
Open the black tank gate valve and press and hold the macerator button to empty black tank. * Note – Pouring water down the coach toilet
while pumping will assist in cleaning out any remaining sediment in the toilet and black tank.*
After pumping contents of black tank, close the gate valve and open the grey tank gate valve. Press and hold the macerator button to empty the
contents of the grey tank. * Note – Dumping the contents of the grey tank will assist in cleaning the macerator hose of any contents left
behind from the dumping of the black tank.*
* Note – If the macerator becomes clogged during pumping, release the macerator discharge pump button. Use the macerator override handle
to loosen the object. Push the handle in and turn the handle left and right to attempt to loosen the clogged object. (Picture 53.3)
Picture 53.1
Macerator Hose and Tank Gate Valves.
Roadtrek Inc.
Picture 53.2
Macerator Discharge Button.
Picture 53.3
Macerator Override Handle.
53