Coming Home - Roadtrek CS Adventurous 2019 Owner's Manual

Coming Home

When you come home, there are a few maintenance tasks you should do to get your Roadtrek ready to go for next time. Refer to other sections in
this manual for the procedures listed here.
• On your way home, dump the grey and black waste water tank at a convenient facility. See the HOW TO's: Waste Water Dumping for a
concise description of the procedure to do this. Some RV parks and gas stations will let you dump for a fee, some city wastewater plants
will let you dump for free but there is no real pattern, so local knowledge is vital in locating dump stations.
• The website http://www.sanidumps.com is a good resource. The website with maps for each state and province is
http://www.sanidumps.com/maps/help.php.
•
At home, flush the water tank and fill it with fresh chlorinated water if you will be using it in the next few days. Otherwise, drain the tank.
Don't let water you are planning to use sit in your tank for more than a week or so, and don't let any water sit in your tank for more than
two weeks, whether you plan on using it or not. Over time, the chlorine evaporates allowing bacteria to grow.
•
To flush the tank, fill it using the fill port located on the driver's side body panel located just behind the front axle under the running board
or the gravity fill located on the passenger side front door pillar. (See images below) (Picture 12.2).
Picture 12.1
30AMP Power Plug Connector.
Located in Drivers Side Running Between
Front and Rear Axles.
Roadtrek Inc.
Picture 12.2
City Water Intake Located Behind Front
Axle on Drivers Side Behind Hinged
Running Board.
12