Utilities; Fresh Water - Roadtrek CS Adventurous 2019 Owner's Manual

Utilities

Just like your house, your Roadtrek has fresh water, electricity, waste water disposal, heating and cooling systems. In the Roadtrek these systems
are self-contained and travel with you. Your vehicle should be reasonably level to allow for normal operation of these systems.

Fresh Water

Your fresh water tank uses a gravity fill system, located in the front passenger's side door pillar. (Picture 47.1) You can fill the fresh water tank from
a convenient water spigot and designated water fill hose. (Do not use a garden hose unless it is for Potable Water.)
To fill the tanks, open the passenger's side front door and remove the orange plug. Remove the black protective cover and make sure the water
intake line ball valve is in the open position. (Picture 47.2 and 47.3) *Note – Do not run the hose bib wide open, fill tank slowly.*
When the tank is full, water will flow out of the fill port. Check your monitor panel to determine when the fresh water tank is full. When full, turn the
water intake valve ball to the closed position to use the water in the fresh water tank. *Note – If left in the open position, air will build up in the
water line and affect your water pressure.*
Roadtrek recommends that you use a dedicated single-purpose potable water hose. These are usually white in color. Use this hose
only for filling your tank and connecting to city water. Always flush faucets and hose thoroughly before use.
Picture 47.1 Picture 47.2 Picture 47.3
Black Protective Cover Housing Water
Fresh Water Tank Fill Located in Fresh Water Intake Valve in Closed
Passengers Side Door Pillar. Intake Line Ball Valve Joint. Position. Turn Parallel with Water
Line to Allow for Fill Up of Fresh
Water Tank.
Roadtrek Inc.
47