Roadtrek CS Adventurous 2019 Owner's Manual page 52

Utilities Continued:
Heating Continued:
Alde Frost Protection Mode
The Alde system will protect itself from freezing by dumping the water in its tank if the temperature approaches freezing.
If your Alde system has dumped, you will need to reset the frost control valve. Open the compartment that houses your Alde, turn the frost
control valve 90 degrees from its tripped position to reset and press the Alde reset button on the side of the control-valve housing. (Picture
52.1)
*Read the Alde Appliance Manual for Specific Operating and Reset Instructions.* "Note - Never Block or Obstruct the Air Ducting
Alde Engine-Heat Exchanger and Engine Pre-Heat
When Operating Your Furnace."
The Alde system is provisioned with an engine heat-exchanger. The heat exchanger can pre-heat your engine in cold temps. The switch for
the engine pre-heat is located on the passenger seat pedestal. (Picture 52.2)
Picture 52.1
Picture 52.2
Alde Frost Control in Operating Mode.
Alde Engine Pre-Heat Switch Located on
Turn to Right to Reset if Tripped.
Passenger Seat Pedestal.
Roadtrek Inc.
52