Table of Contents
Advertisement
NORMA 6003/NORMA 6003+/
NORMA 6004/NORMA 6004+
User Manual
Operation
Global Configuration
Under all view modes (Meter, Scope, Trend, Phasor and Harmonic), the soft key
The Configure soft key is global configuration and is applied to all other modes.
Use the Configure menu to set the Analyzer's range for each channel, timing synchronization, wiring,
formula, zero and formula editing.
This section explains in detail the functions and operation of the Configure menu.
Enter the Configure Menu:
From the Main screen of any view mode select
•
The functions in the Configure menu are as shown in
Item
Range
Wiring
Timing Sync
Zero
Formula
Set Range
1. From the Main screen of any view mode, select
(CH1).
2. The Configuration interface of channel 1 is as shown in
18
Table 7. Global Configuration
Description
A
Sets the voltage/current range for each channel, ratio, filter, and selects
whether to use an external sensor. NORMA 6003+ and NORMA 6004+ can
also set the mode and ratio of the motor torque/speed measurement.
See
for details
Set Range
B
Sets the wiring selection and the synchronization source of each wiring group.
For detailed information, see
C
Sets the sync source of each wiring group. For detailed information, see
Sync Source and Update Rate.
D
Eliminates the Analyzer's input offset by zeroing. See
E
Defines the efficiency formula and the formula for some numerical calculation.
See
Define Calculation Formula
(Configure).
A
Table
7.
Set the Wiring
Selection.
for details.
(Configure) >
A
Table 8.
is Configure.
A
Set
Zero.
(Range) >
A
A
Advertisement
Table of Contents
