After-Cleaning Care - Bissell TURBOCLEAN POWERBRUSH PET 2806 Series Manual

After-Cleaning Care

For more tips on maintaining your machine, visit support.BISSELL.com.
1.
Turn OFF and unplug your
machine. Follow steps 2 & 3 in
the section above to remove
the Dirty Water Tank.
4.
Ensure the Dirty Water Tank
is empty by gently removing
the float stack and unscrewing
the ring at the bottom of the
tank. Follow steps 4 & 5 on
page 5.
7.
To replace the Nozzle, align
top into channel in front of red
filter and press in place.
ATTENTION
latched appropriately. Return Dirty Water Tank to the machine and try cleaning again.
WARNING
electrical outlet before performing maintenance or troubleshooting.
6 BISSELL.com
2.
Grab the top of the Nozzle
and pull it up and away from
the machine. Rinse or wipe
it clean. Use a cloth to wipe
debris from the red filter.
5.
Clean and rinse debris from
the float. Keeping the float
clean prevents your Dirty
Water Tank from overflowing
and ensures the seal stays
intact.
8.
Use both hands to push the
bottom portion of Nozzle into
place.
If you experience no suction, remove the Dirty Water Tank and ensure the Nozzle is secured and
To reduce the risk of fi re, electric shock or injury, turn power OFF and disconnect plug from
3.
Use cloth to wipe brush roll
cover clean.
6.
Once clean, assemble by
aligning the arrow on the float
with the notch on the tank.
Then, return the ring and twist
to lock. Make sure it's fully
aligned, so water doesn't leak.
9.
Once Dirty Water Tank is
dry align the bottom of the
tank to the base and secure
into place with latches.