Using Cancel/Drain - Whirlpool SERIES 940 Use And Care Manual

CYCLE
HEAW
A "0" shows what each cycle includes
CYCLE
MAIN
FINAL TIME
WASH RINSE WASH RINSE RINSE DRY (Minutes
Double wash for cleaning heavily
IiiiiI
soiled loads.
l Select High Temp Wash
to heat water in the main
wash (markedr).
l
The water heats to 140°F
(60%) in the final rinse (marked n).
.
. et .
l tt
. 76'
POTS-N-PANS
Double wash for maximum cleaning
of cooked-on or baked-on foods.
liiiii
l
The water heats to 140°F
(60%) in both washes
at .
l t . Ott .
76'
. .
(markedr).
-
l
The water heats to 140°F
(6O'C) in the final rinse
(marked fi).
'Cycle time indudes dry time and may be longer depending on the temperature of water entering the dishwasher.
The cooler tha water, the longer the cycle time. H the waler is already hot enough, the cycle times will be as shown.
Using Cancel/Drain
Press Cancel/Drain to cancel a cycle or to
dear the indicators.
To clear the indicators:
Press Cancel/Drain before starting the
dishwasher to clear all cycle and option
selections.
To cancel a cycle:
l
Press Cancel/Drain while the dishwasher
is running to start a 2-minute drain. It will
take a few seconds for the drain to start.
If desired, select a new cycle. (See the
"Changing a cycle or option setting"
section.)
l
You can press Cancel/Drain again to stop
the drain immediately. Remember to drain
the dishwasher again before starting a
new cyde.
NOTE: A small amount of water remaining
in the dishwasher is normal.
14