Whirlpool SERIES 940 Use And Care Manual page 12

Using the rinse agent dispenser
Keep the rinse agent dispenser filled with a
liquid rinse agent. A rlnse agent greatly
Improves dish drylng by helplng water
flow off them during the last rlnse. A rinse
agent also keeps water from forming drop-
lets and drying as spots or streaks.
A small amount of rinse agent automati-
cally releases into the rinse water during the
final rinse of each cycle. For best drylng
results, check dispenser perlodlcally to
see if It needs filling.
To check dispenser:
_
l
Check center of Fill Indicator Cap. Clear
means it needs filling.
OR
l
Remove Fill Indicator Cap. An 'E" is visible
when dispenser is empty.
To fill dispenser:
The rinse agent dispenser holds 6 ounces
(175 mL). Under normal conditions, this
lasts about 3 months.
1. Open dishwasher door completely.
2. Remove Fill Indicator Cap.
3. Add rinse agent. Fill to smallest opening
in lower part of dispenser only. Overfilling
may cause rinse agent to leak out. This
will not harm the dishwasher, but could
cause oversudsing.
4. Clean up any spilled rinse agent with a
damp cloth.
5. Replace Fill Indicator Cap. Keep it closed
tightly.
NOTE: You do not have to wait until the
dispenser is empty before refilling, but do
not overfill it. Your dishwasher is designed to
use a liquid rinse agent. You do not need to
use a solid or bar-type rinse agent.
Cap center clear
"E" vlslble
when empty
when empty
Do not fill
past
smallest openlng
Keep dlspenser fllled for best drylng results
12