Sirius Satellite Radio SLTC61 Instructions For Use Manual page 16

MAINTENANCE
* An accurate maintenance guarantees good
functioning and long-lasting performance.
* Particular care is due to the grease filter
panel.
In order to remove the grease-filter in models
SLTC61, SLTC65, SLT66 and SLTC68 it is ne-
cessary to open the front panel first (Fig. 6),
then grasp the filter handle and rotate it ou-
twards. To insert the filter please follow the
inverse procedure.
For model SLTC62, it is necessary to open
the front glass panel, by rotating it upwards
(Fig.12), then take the two grease-filters out
from their seat, as shown in Fig. 12 A.
To insert the filter please follow the inverse
procedure.
After 30 hours working (model SL-Modu-
le Luxury version), the push button control
panel will signal the saturation of the grease
filter by lighting all the buttons. In the SLTC
models (Touch Control Version) the grease
filter saturation is signalled by the flashing
of the two central push buttons (Fig. 21 C).
Press the timer button to reset
The grease filter needs cleaning by regular
hand-washing or in dishwashers every two
months at least or depending on its use.
* In case the appliance is used in its filtering
version, the active coal filter (Fig.16-20Z)
needs to be periodically replaced.
The coal filter can be removed by removing
the grease filter first (Fig.4A-16B), and by
pulling its special plastic tongue until it is un-
fastened from its slot. Re-insert the coal filter
by operating in the opposite way. The coal
filter needs replacing depending on the use,
but however every six months at least.
* To clean the appliance itself tepid water and
neutral detergent are recommended, whi-
le abrasive products should be avoided. For
steel appliances specialized detergents are
recommended (please follow the instructions
indicated o the product itself to obtain the
desired results).
SLTC61 LAMP REPLACEMENT
To replace the adjustable dichroic lamp, first,
remove the supporting ring nut by clasping
its adjacent edges (Fig.13), then remove the
lamp and replace it with another one with the
same characteristics.
SLTC62, SLTC65, SLT66 and SLTC68 LAMP
REPLACEMENT
To replace the dichroic lamp, remove the
lamp (Fig. 19) by inserting a screwdriver or
another sharp tool between the lamp and its
chrom support and replace it with a lamp of
the same kind.
* If the supply cord is damaged, it must be
replaced by the manufacturer or its sevice
agent or a similarly qualified person in order
to avoid a hazard.
.
16