Advertisement
Available languages
Available languages
WORKING
Mod. SL TC - Touch Control version (Dis.21)
A: Light switch On/Off
B: Reduce speed
C: Luminous telltale
D: Incrase speed
E: 10 - minute timer
The touch control key allows the function
desired by touching the relative key. The lu-
minous telltales (fig. 16C) positioned at the
center of the keyboard indicate the suction
speed set. In case of an active timer, the up-
per telltale (C) flashes.
If the push button console malfunctions, re-
move the grease filters and press the red but-
ton inside the appliance twice.
If the electrical power supply to the product
SLTC is cut, 15 seconds are needed for self-
diagnostics after the functions are restored. In
the meanwhile, its operation may be incorrect.
Mod. SL TC - Glass (Dis.24)
A:
Light switch On/Off
B:
Reduce speed
C:
Luminous telltale
D:
Incrase speed
E:
10 - minute timer
The touch control key allows the function de-
sired by touching the relative key.
If the electrical power supply to the product
SLTC is cut, 15 seconds are needed for self-
diagnostics after the functions are restored. In
the meanwhile, its operation may be incorrect.
Mod. SLT
Technical data:
Alkaline battery powered: 12v mod. 23A
Operating frequency: 433.92 Mhz
Combinations: 4096
Max. consumption: 25mA
Operating temperature: -20° : +55°C
- To light the cooker hood on or to
light it off press the button:
- To increase the speed up to the
fourth one press the button:
- To reduce the speed up to the
second one press the button:
- To go from a high speed back to
the first one press twice the button:
- To give power to the lights or to
shut them down press the button:
- To set the timer up press the
button:
The LED on the right side will start to flash
(every 5 seconds), the hood will work for 10
minutes at the selected speed and then it li-
ghts automatically off. If the client increases
or reduces the speed while the timer is on,
this is automatically stopped.
Standard configuration
If two cookerhoods-radiocontrol system are
installed in the same room or in the immediate
vicinity, each system may affect the operation
of the other, due to the fact that they have the
same code. Therefore it will be necessary to
change the code of one of the radio controls.
14
Advertisement
