Peripheral Equipment - Furuno Inmarsat FleetBroadband FELCOM251 Installation Manual

5.9

Peripheral Equipment

5.9.1 Telport extender (Option)
Telport extender FB-3002 provides extended telephone ports.
Wiring
1. Loosen the two binding screws then remove the case from chassis.
2. Make a slit on each grommet to pass the cables.
Make holes in the
grommet to allow
cable entry.
3. Pass a modular cable from communication unit through the grommet and then
connect the Phone/Fax1 port on the board of telport extender.
4. Pass another modular cable through the grommet and connect Phone/Fax2 port.
5. Pass a signal cable (TTYCSLA-1, local supply) through the grommet and then
connect to TEL1 terminals.
Make a slit for
passing the
cables
Cable tie
Telephone
modular cable
TTYCYSLA-1
6. Connect three signal cables to TEL2, TEL3 and TEL4 ports as same as step 5.
7. Fix the cables to cable clamp with cable tie.
8. Attach a modular jack box onto another end of each cable.
9. Attach the case to the chassis then fasten the binding screws to secure.
Modular cable
grommet
TEL1/3, TEL2/4
from the left
5. HARDWARE INTERFACES
Make slits in the
grommet to allow
cable entry.
TTYCSLA-1
cable grommet
Telephone terminal
TEL1, TEL2, TEL3, TEL4
from the left
5-9