Selecting Cycle Options; Changing A Cycle Setting; Changing An Option Setting - Whirlpool 910 Series Use And Care Manual

SETTING THE CONTROLS

Selecting cycle options

If desired, press one or more Option pads.
You can press an Option pad after the dish-
washer starts as long as the cycle has not
passed the point that the option is used. For
example, you can press Air Dry any time
before the Cycle Control knob reaches Dry.
High Temp Wash
When High Temp Wash is
HIGH TEMP
selected, the dishwasher heats
WASH
the water during the main wash of
the Light and Normal cycles.
Heating the water helps improve
washing results. The Pots-N-Pans cycle
automatically uses High Temp Wash.
NOTE: The Cycle Control knob does not
move while water is being heated. Once the
water reaches the proper temperature, the
Cycle Control knob will begin moving again.

Changing a cycle setting

You can change a cycle setting anytime
during any cycle.
1. Lift up the door latch to stop the cycle.
2. Turn the Cycle Control knob clockwise to
the desired cycle.
3. If desired, press one or more Option pads.
4. Check the detergent dispensers. They
must be filled properly for the new cycle.

Changing an option setting

You can change option settings anytime
during a cycle as long as the
cycle has not passed the point
RESET
that the option is used. For
example, you can press Air
Dry anytime before the Cycle
Control knob reaches Dry.
1. Press the Reset pad.
2. Press 1 or more Option pads.
14
Air Dry
When Air Dry is selected, the air in the
dishwasher is not heated during
AIR
the "dry" portion of a cycle. Using
DRY
Air Dry helps save energy, but
dishes take longer to dry and
some spotting can occur. Some
items (such as plastics) may need towel
drying. For best drying, use a liquid
rinse agent.
NOTES:
• The dishwasher automatically heats the air
in the dishwasher during the "dry" portion
of the cycle unless you select Air Dry.
• Always select the Air Dry option when
using the Rinse Only cycle.
NOTE: Turning the Cycle Control knob
can cause the covered section of the
detergent dispenser to open and release
the detergent. Check the covered section
if setting a cycle.
5. Close the door firmly until it latches. The
dishwasher starts the new cycle.