Setting The Controls; Selecting A Wash Cycle - Whirlpool 910 Series Use And Care Manual

Setting the Controls

Selecting a wash cycle

Press a Cycle pad. (Normal Wash, Light Wash and Rinse Only share the same pad.) Turn
the Cycle Control knob to the desired cycle.
CYCLE
POTS-N-PANS
POTS-N-PANS
• The water heats to 140°F (60°C) in
both washes.
• The water heats to 140°F (60°C) in
the final rinse.
NORMAL WASH
NORMAL
WASH
is based on this cycle.)
• Select Hi-Temp Wash to heat water
to 140°F (60°C) in the main wash.
• The water heats to 140°F (60°C) in
the final rinse.
LIGHT WASH
LIGHT
WASH
• Select Hi-Temp Wash to heat water
to 140°F (60°C) in the main wash.
• The water heats to 140°F (60°C) in
the final rinse.
Cycle time includes dry time and may be longer depending on the temperature of water entering the dishwasher. The cooler the
†
water, the longer the cycle time. If the water is already hot enough, the cycle times will be as shown. The Cycle Control knob does
not move while water is being heated.
12
Double heated
washes for cleaning
of cooked-on or
baked-on foods.
Double wash for
normal, everyday
soiled loads. (The
Energy Guide label
Single wash for
pre-rinsed or lightly
soiled loads.
A " • " shows what each cycle includes
WASH RINSE
•
•
•
MAIN
WASH RINSE
•
•
• •
• •
CYCLE
TIME
DRY (Minutes)
•
†
88
•
†
72
•
62 †