Changing A Cycle Setting; Changing An Option; Canceling A Cycle; Cycle Selection Chart - Whirlpool 8900 Series Use And Care Manual

Changing a cycle setting
You can change
a
setting anytime during any cycle.
1.
Lii up on the door latch to unlatch the
NOTE:
Turning the Cycle Control knob
door and stop the cycle.
may cause the covered section of the
2. Turn the Cycle Control knob clockwise to
detergent dispenser to open. Be sure to
the cycle you want.
fill the covered section if the cycle uses
3. Push the desired Cycle Selection button.
detergent in both sections.
4. Check the detergent dispenser to be sure
5. Close and latch the door. The dishwasher
it is properly filled for the new cycle. See
will automatically start the new cycle.
page 12.
Changing an option
You can change an option anytime during a
cycle. To change the selected option(s):
1.
Push the RESET OPTIONS button.
2. Push an Option Selector button for each
desired option.
Canceling a cycle
You can cancel a cycle anytime during the cycle.
1.
Turn the Cycle Control knob slowly
2.
Let the dishwasher drain completely.
clockwise to the drain portion of the wash
3. Lii up on the door latch to unlatch the
or rinse. You will hear water draining
door.
when you have advanced to the proper
location.
4. Turn the Cycle Control knob clockwise to
point to OFF.
Cycle selection chart
,
cycle
Pots & Pans
A double wash for
maximum cleaning
of cooked-on or
baked-on foods.
NOTE: The Cycle Control knob
stops while the dishwasher heats
water to 135°F (57°C) in both
washes and the final rinse
(marked T). See page
10.
A "en shows what steps are in each cycle Cycle
Main Time
Wash Rinse Wash Rinse Rinse
Dry (Minutes)
l t . l t 0 l t
.
90-l 20'
8