Table of Contents
Advertisement
Quick reference guide
(see at right for options description)
PROGRAM SELECTION
START/RESUME BUTTON
BUTTON
Push this button to start the selected program: the
Push "P" button (repeatedly)
indicator lights up and goes off at the end of the
until selected program number
program.
is shown on the display
When the door is opened during a washing cycle,
(P1...Px) - see "Table of
the cycle is temporarily paused: the Start indicator
programs" below.
blinks. To resume the cycle close the door and
push Start button again.
Table of programs
Available
Programs
options
6th Sense
P1
Power
40°-70°C
Power Clean
Clean
P2
Pre-Wash
cold
P3
Fragile
40°C
P4
Rapid
45°C
P5
2)
50°C
Eco
Power Clean
P6
Fast Daily
60°C
P7
Intensive
65°C
Power Clean
P8
3)
Hygiene
Power Clean
1)
Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on conditions.
Differences of up to 20 minutes are possible with sensor programs as a result of the appliance's automatic calibration system.
2)
Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: "nk_customer@whirlpool.com".
3)
The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
Whirlpool is a registered trade mark of Whirlpool USA
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
Loading instructions
Use for normal soiled dishes with dried-on food.
Senses the level of soiling on the dishes and
adjusts the program accordingly. When the sensor
Delay
is detecting the soil level an animation appears in
the display and the cycle duration is updated. The
Power Clean option is activated automatically
with this program. To deactivate, press the Power
Clean button on the control panel.
Delay
Crockery to be washed later.
Delay
Light soiling, for example glasses and cups.
Delay
Lightly soiled crockery, with no dried-on food.
Delay
Normally soiled crockery.
Energy-saving program.
Delay
Normally soiled crockery.
Delay
Recommended program for heavily soiled crockery,
especially suitable for pans and soucepans.
Normally or heavily soiled crockery, with additional
Delay
antibacterial wash. Program interruption (e.g. due to
door opening) can compromise elimination of
germs.
Options and display description
Consumption
Deter-
Drying
gent
Phase
Litres
kWh
1)
Minutes
X
7-14 1.00-1.65
80-165
Full
—
4.0
0.03
14
NO
X
10.0
0.85
100
Light
X
11.0
0.80
30
NO
X
11.0
0.92
230
Full
X
10.0
1.30
80
Full
X
14.0
1.60
145
Full
X
13.0
1.50
118
Full
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With "Delayed start" selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If "Fx Ey" messages appears on the display, see page 6 - chapter "What to do if...".
POWER CLEAN
TABLET SETTING
Thanks to the additional
This setting allows to optimize
power jets this option
the cycle performances
provides a more intensive
according the type of detergent
and powerful wash in the
used. Push the Tablet button
Lower Rack, in the specific
for 3 seconds (until the
area. This option is
indicator lights up) if you are
recommended for washing
using the combined detergents
pots and casseroles (see page
in tablet (rinse aid, salt and
4). Press this button to
detergent in 1 dose). If you are
activate Power Clean (the
using powder detergent or
indicator lights up).
liquid detergent, the Tablet
For non Power Clean loading
indicator on the control panel
to achieve best cleaning
has to be off.
performances and resources
optimization, Power Clean
should be switched off.
Chart
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
DELAYED START BUTTON
Push the button (repeatedly)
to delay the start of the
program. Adjustable from 1 to
24 hours. With each press of
the button, the delayed start
indicator increases by one
hour and after 24 restarts from
0. Then press the START
button. The dishwasher will
start after the set time.
5019 396 03695
GB -1-
Advertisement
Table of Contents
