What Happens In Each Option - Whirlpool 8900 Series Use And Care Manual

Cycle
China Crystal
A light wash with a
gentle dry designed for
china and crystal.
NOTE: The Cycle Control knob
does not move
while the dishwasher
heats water to 135°F (57%) in the
final rinse (marked t) if the Lo-Energy
Rinse option is not selected.
If the Hi-
Temp Wash option Is selected
water will also be heated in the main
wash(marked~).SeepageslOandll.
Rinse & Hold
use detergent. Use Air Dry option.
Drying with heat may cause food to
bake on dishes.
IP
\ '0" shows what ste ?P! s are in each
I C!
ycle
Vash Iinse
Main
Vash
d-t
Iinse
.
.
Iinse
l t
0
DV
.
60'
l-
!I
Cycle
Time
Minutes)
16
l
Cycle time includes heated dry time. Cycle time may vary depending on the temperature of
the water entering the dishwasher.
What happens in each option
A note about water heating
The dishwasher can heat water during
portions of all cycles except Rinse & Hold.
NOTE:
l
The WATER HEATING signal light will
glow while the water is heating.
. The Cycle Control knob does not move
while the water is heating.
l
When the water temperature reaches
135°F (57°C) the Cycle Control knob will
begin moving again.
l
The heating time is based on the tempera-
ture of the water suppty as it enters the
dishwasher. The cooler the water, the
longer the heating time.
If water temperature at the faucet is
below 120°F (49°C) have a qualified
person raise the water heater's thermostat
setting. See page 16.
10
l
The dishwasher does not pause to heat
the water if the water entering the dish-
washer is already 135°F (57°C).