Table of Contents
Advertisement
Structure and function
3
Function
3.3.3 Test mode
3.3.4 Alarm activation
3.3.5 Diagnosis levels
20 | 46
Please also observe the documentation for your fire detection system.
A test mode can be set on the control panel to test the radio manual call points.
When in test mode, alarms from the radio manual call points are not forwarded by
the control panel.
Press the pressure point on the glass or plastic insert.
l
a
The plastic insert falls down or
a
The glass insert breaks.
a The alarm is activated
After an alarm is activated, the manual call point must be reset to a state in which it
is ready for operation.
The radio manual call point monitors its operation largely autonomously.
The following diagnosis levels are derived from the different control measurements:
●
Normal
●
Replacement necessary
●
Fault
When an error which impairs the radio manual call point's function occurs, a fault
message is signaled. To correct the cause of the fault, additional information is
available in the radio manual call point. This can be indicated with the FXS2061
SWING Tool. You will find more information in document A6V10227643. See
chapter 'Applicable documents [➙ 7]'.
A6V10401120_g_en_--
Advertisement
Table of Contents
