Removing blockages or build-ups:
■ Switch the appliance off, wait until the
drive has come to a standstill and pull
out the mains plug.
■ Remove the lid of the continuous-feed
shredder and empty the feed chute.
■ To remove food stuck underneath the
cutting disc, take off the continuous-feed
shredder, followed by the disc and disc
carrier and remove the blockage.
Cleaning and maintenance
The attachments and accessories used
must be thoroughly cleaned after each use.
W Risk of injury
Never grasp the sharp blades or edges
of the cutting discs. Grip the discs by the
plastic part in the centre only!
Caution!
– Do not use any cleaning agents
containing alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
– Do not wedge plastic parts in the
dishwasher as they could become
permanently deformed.
Dismantling the continuous-feed
shredder
■ Dismantle the continuous-feed shredder
as described under "Preparation" but
in reverse order. X "Preparation" see
page 6
In Fig. D you will find a summary of how to
clean the individual parts.
Note: When processing food such as
carrots, the plastic parts may become
discoloured, but this can be removed with a
few drops of cooking oil.
Cleaning and maintenance
Predetermined breaking
point
To prevent serious damage to your
appliance, the drive shaft of the accessory
is protected with a built-in predetermined
breaking point. If an overload occurs,
the drive shaft of the continuous-feed
shredder will break.
Spare parts with a predetermined
breaking point are not covered by our
warranty obligations. A new disc holder
is available from customer service
(order no. 10000314).
Subject to change without notice.
en
7