Adjusting The Cutting-Unit Steering - Toro Edge Series Operator's Manual

4. Install the O-ring on the reel motor
1. O-ring
5. Install the reel motor, and grease the side plate until
excess grease comes out of the grease vent
5
Adjusting the Cutting-Unit
Steering
No Parts Required
Increased Steering for the Rear Cutting
Units
Increase the steering on the rear cutting units by removing
the 2 pivot spacers, hex socket screws, and flange locknuts
(Figure 8) from the carrier frames of the rear cutting units
(cutting units 2 and 3); refer to
1. Hex socket screw
2. Pivot spacer
(Figure 7).
Figure 7
(Figure
Figure 9.
1
2
3
G015978
4
Figure 8
3. Carrier frame
4. Flange locknut
1. Cutting unit 1
g191072
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
6).
Locking the Steering
To lock (fix) the steering on the cutting units, secure the pivot
yoke to the carrier frame with the snapper pin
1
1. Snapper pin
Note: Fixed steering is recommended when cutting
side hills.
g015978
6
Figure 9
5. Cutting unit 5
6. Reel motor
7. Weight
(Figure
G015977
Figure 10
g031275
10).
g015977