Parameter Initial Value Groups - Mitsubishi Electric 800 Series Instruction Manual

3.4

Parameter initial value groups

• Initial values of parameters of the FR-E800 differ depending on the parameter initial value group. In this Instruction Manual,
Gr.1 indicates the parameter initial value group 1, and Gr.2 indicates the parameter initial value group 2.
• FR-E800 inverters are divided into two groups as shown in the following table.
Parameter initial value groups
Group 1 (Gr.1)
Group 2 (Gr.2)
• The initial values of the following parameters differ depending on the parameter initial value group.
Pr.
3 Base frequency
4 Multi-speed setting (high speed)
19 Base frequency voltage
20 Acceleration/deceleration reference frequency
55 Frequency monitoring reference
66 Stall prevention operation reduction starting frequency
125 Terminal 2 frequency setting gain frequency
126 Terminal 4 frequency setting gain frequency
249 Earth (ground) fault detection at start
301 BCD input gain
303 BIN input gain
390 % setting reference frequency
505 Speed setting reference
808 Speed limit
1486 Load characteristics maximum frequency
*1 The parameter is available when the plug-in option (FR-A8AX) is installed. For details, refer to the FR-A8AX Instruction Manual.
*2 For details, refer to the Instruction Manual (Communication).
82
3. Parameters
3.4 Parameter initial value groups
Model
FR-E800-1 RS-485 communication, terminal FM
FR-E800-5 RS-485 communication, terminal AM
FR-E800-EPA Ethernet communication (Protocol group A)
FR-E800-4 RS-485 communication, terminal AM
FR-E800-EPB Ethernet communication (Protocol group B)
Name
Specification
Initial value
Refer to
page
Gr.1 Gr.2
60 Hz 50 Hz 376
60 Hz 50 Hz 195
9999 8888 376
60 Hz 50 Hz 158
60 Hz 50 Hz 228
60 Hz 50 Hz 214
60 Hz 50 Hz 273
60 Hz 50 Hz 273
0 1 204
*1
60 Hz 50 Hz
*1
60 Hz 50 Hz
*2
60 Hz 50 Hz
60 Hz 50 Hz 226
60 Hz 50 Hz 120
60 Hz 50 Hz 219