Tightening Torsion Rods; Secure Hold Open Cam - Hussmann EcoVision II Plus Door Upgrade Installation & Service Manual

For tyler n6d multi-deck merchandisers

Table of Contents

P/N 0530690_B

Tightening Torsion Rods

A. Once doors are correctly aligned, tighten

torsion rod at bottom of doors - (6 clicks).

NOTE: Refer to illustrations on the next

page for additional door adjustment

information.

A. Align cam slot over threaded hole in hinge

plate assembly. Install screw through cam

and connect to hinge plate. EcoVision II Plus

doors have a hold open latch that allows the

doors to remain in an open position. This

feature is especially useful for stocking the

merchandiser with product or cleaning the

merchandiser's interior. Fasten hold open cam

screw as shown. Never spread cam with screw

driver!

Bottom Hinge

Plate Hole

U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com

Table of Contents