Table of Contents
Advertisement
Available languages
Available languages
Operating the product
5.13 Changing the program after it is
started
You can change the program you selected to dry your
laundry with a different program after the machine
starts running.
•
For example, to select Extra Dry instead of Iron Dry,
pause the program by pressing the Start / Stand-
by button.
•
Select the Extra Dry program using the Program
Selection button.
•
Press the Start/Stand-by button to start the
program.
Adding and removing clothes during stand-by
•
If you want to add or remove clothes to/from the
machine after the drying program starts:
•
Press the Start/Stand-by button to put the machine
in Stand-by state. The drying operation stops.
•
Open the loading door while in Stand-by state, and
close the door after you remove or add laundry.
•
Press the Start/Stand-by button to start the
program.
C
Adding laundry after the drying operation
starts may cause the dried laundry inside
the machine to mix with wet laundry and
leave the laundry damp at the end of
operation.
C
Adding or removing laundry during drying
may be repeated as many times as you
wish. But this operation continuously
interrupts the drying operation, and thus
increases program duration and energy
consumption. So, it is recommended to
add laundry before the program starts.
C
If a new program is selected by turning
the program selection knob while the
machine is in stand-by; the running
program terminates and new program
information is displayed on the screen.
WARNING: Do not touch the inner surface
of the drum while adding or removing
clothes during a continuing program. The
drum surface is hot.
Dryer / User Manual
5.14 Cancelling the program
If you want to cancel the program and terminate the
drying operation for any reason after the machine starts
running, keep the On/Off/Cancel button pressed for 3
seconds.
A
WARNING: The inside of the machine
shall be extremely hot when you cancel
the program during machine operation, so
run the ventilation program to allow it to
cool down.
5.15 End of program
When the program ends, the Fibre Filter Cleaning
and Water Tank warning symbols on the program
observation indicator turn on. Loading door may be
opened and machine becomes ready for another run.
To turn off the machine, press the On/Off/Cancel
button.
C
Wrinkle Prevention function activates the
2 hour-Wrinkle Prevention program if
laundry isn't taken out of machine after
completion of the program.
C
Clean the fibre filter after each drying. See
6.1 Cleaning Lint Filter / Loading Door
Inner Surface
C
Empty the water tank after each drying.
See 6.3 Draining the water tank
23 / 60 EN
Advertisement
Table of Contents
