Dremel 1453 Original Instructions Manual page 5

ATTACHMENT FOR USE WITH DREMEL ROTARY TOOL MODELS 3000,
4000, 4300, 7760, 8220, 8260.
Please check our website for the latest update on compatibility at:
www.dremeleurope.com/support
DISCONNECT THE PLUG FROM THE POWER SOURCE BEFORE
!
MAKING ANY ADJUSTMENTS, CHANGING ACCESSORIES, OR
STORING POWER TOOLS. SUCH PREVENTIVE SAFETY MEASURES
REDUCE THE RISK OF STARTING THE POWER TOOL ACCIDENTALLY.
Depending on your particular chain size, make sure you assemble your new
sharpener properly as follows:
1. Refer to
7
2. When you have determined the correct grinding stone for your chain
from the drawing, assemble the attachment by screwing the guide and
appropriate number of spacers to the clamp using the two screws, as
shown in
8
Diameter
5.5 mm
4.8 mm
4.5 mm
4.0 mm
3. Securely mount the correct grinding stone in your tool with
approximately 6 mm of the shank exposed between the chuck cap and
the stone
9
4. Remove the housing cap and screw on the chain saw sharpening
attachment
A q
Using the appropriate side of the gauge, adjust the guide so it is properly positioned
with respect to the grinding stone and tighten the screws. The gauge must be flush
with the corner of the guide while making contact with the grinding stone A a .
ASSEMBLY
for the correct grinding stone.
.
Colour
pink
orange
white
blue
.
.
No. of spacers
2
1
1
–
5