Pressure Set Valve Replacement; Pressure Relief Valve Replacement (1,500 And 12,000 Psi) - Graco Renegade Series Operation - Repair - Parts

5. Lift the black solenoid to gain clearance
to the 7/8 in. hex on the body of the
poppet valve. Loosen and remove.
6. Install new solenoid valve without the
new 3/4 in. top retaining nut.
7. Torque the 7/8 in. hex to 19-21 ft. lbs
(25.8-28.5 N m).
•
8. Reinstall the top 3/4 in. retaining nut,
torque to 4-5 ft. lbs (5.4-6.8 N
9. Reconnect the terminal and tighten
Phillips head screw.
10. Reinstall shroud and top half of frame.
3A6884B
Pressure Set Valve
Replacement
Tools Required: 1-1/16 in. wrench.
1.
2.
3.
4.
Pressure Relief Valve
Replacement (1,500 and
12,000 PSI)
Tools Required: 16 mm wrench.
1.
m).
•
2.
3.
Perform Pressure Relief Procedure,
page 10 and disconnect power to the
TSP power pack.
Use a 1-1/16 in. wrench to loosen.
Remove plastic protective cap from new
valve. Ensure washer remains on new
valve.
Screw in new valve by hand. Tighten to
57-61 ft. lb (77.2-82.7 N
Perform Pressure Relief Procedure,
page 10 and disconnect power to the
TSP power pack.
Loosen and remove valve with 16 mm
wrench.
Replace new valve and torque to 50-55
ft. lbs (67.8-74.6 N
1,500 psi relief valve shown
Repair
m).
•
m).
•
33