8. Route all the other power cables neatly, using the cable-management bracket if
Installing the PDU in the side of an IBM Enterprise rack cabinet only
Note: Removing the rack doors and side panels might make installation easier.
See the rack cabinet documentation for more information.
Review the documentation that comes with your rack cabinet for safety and cabling
information. When installing your system in a rack cabinet, consider the following:
v Make sure that the room air temperature is below 35°C (95°F).
v Do not block any air vents, usually 15 cm (6 in.) of air space provides proper
v Connect all power cords to properly wired and grounded electrical outlets.
v Do not overload the power outlet when installing multiple devices in the rack.
12
DPI C13 PDU+, DPI C19 PDU+, and DPI C19 3-phase PDU+: Installation and Maintenance Guide
it is installed, and secure the power cables with cable straps.
Note: To route a power cable through the cable-management bracket, route the
cable through an opening in the bracket and against an upper or lower tab on
the bracket, as shown in the following illustration. Use cable straps as required.
Tab
airflow.