To Start Your Air Conditioner - Whirlpool Coolerator CAW21D2A1 Installation & Operation Manual

To
1
l
2
l
HOW TO STA
YOUR AIR C(:
FRESH AIR AND
EXHAUST CONTROL
ENERGY SAVER
CONTROL
Be sure air conditioner is OFF before plugging it in.
Start Your Air Conditioner
Using the Energy Saver Control
Set exhaust control to OFF for maximum
cooling.
Choose either LO COOL, MED COOL OR HI
COOL fan speed setting.
LO COOL . . . . for sleeping comfort
MED COOL . . . , . . . , , for normal cooling
HI COOL . . . . . . . for maximum cooling
3
l
Turn thermostat control
to Number 6
(midsetting). You can adjust the air condi-
tioner's cooling performance by resetting the
thermostat control to a higher number for
maximum cooling. Lower the number setting
to less cooling. You will need to experiment
to find the setting which suits vou best.
3T AND USE
NDITIONER
(for Energy Saver models only).
1
l
Choose a fan setting: either AUTO FAN or
NORM FAN.
2
l
The AUTO FAN setting saves energy. The fan
will cycle on and off as the thermostat turns
the compressor on and off. This saves the cost
of electrical energy that would be used to run
the fan continuously.
It is normal for the fan to turn on and off in
the AUTO FAN setting. The amount of time
the unit will be off depends on room tem-
perature and thermostat setting.
3
. In NORM
FAN setting, the fan runs all the
time even though the thermostat will turn the
compressor on and off. Use NORM FAN
during extremely warm or humid weather and
for rooms that need to be cooled constantly.
14