Fisher & Paykel EC90 DXV1 Installation Instructions

Designer Series Wall Canopy
80325 – EC90 DXV1 (SS NZ/AUS)
80326 – EC90 DMV1 (IR NZ/AUS)
80387 – EC90 DXV1 (SS EU)
88832 – EC90 DXV2 (SS UK)
Please note product may vary slightly from the picture.
Please read the entire instructions before installing the canopy.
INSTALLATION INSTRUCTIONS
PRE-INSTALLATION
Thank you for purchasing a quality, stainless steel canopy hood.
We have a high standard of quality control and each canopy hood is tested and approved before it
leaves the factory.
IMPORTANT
•
Please read the entire instructions before installing the canopy hood
•
Always switch the power off prior to installation, servicing or cleaning the canopy hood.
•
Never use the canopy hood without the filters.
•
Stainless steel is very easily damaged during installation if abraded or knocked by tools.
•
A power outlet should be within 750mm of the motor assembly and can be either on the wall,
behind the chimney or in the ceiling.
•
To comply to electrical safety regulations this canopy must be plugged into a socket near the
appliance. The socket must be accessible and enable the end user to isolate the canopy from the
power for the purpose of internal cleaning or maintenance.
Ducting accessories are not supplied. All ducting must comply with local requirements and building
codes.
All electrical work must be done in accordance with local and/or national electrical
codes as applicable. For safety, this product must be earthed. If you are unfamiliar with
methods of installing electrical wiring, employ the services of a qualified electrician.
Turn off power at service entrance before installing wiring or servicing this product.
The canopy hood is heavy please ensure adequate care when installing the canopy
hood to prevent personal injury.
lbs
The canopy hood must be installed onto a solid wall, stud, beam or truss. Weight of
product 22.2 kg.
104921 issue A
ECN 06 037
CONTENTS
Contents of packaging Equipment required
1 x canopy hood Electric drill
2 x chimney pieces with bracket Screwdriver
1 x installation instructions Duct tape
3 x filter (part number 104660) Jig saw
Installation kit (part number 104834) Ladder
2 x 12 x 2" screw Ducting
2 x cup washer Tape measure
3 x 8 x 1.25" screw Drill bits
1 x wall anchor Spirit level
4 x 6 x ¼" self tapping screw
HEIGHT OF CANOPYHOOD
C
FILTER SURFACE
HOB TOP
A=600 min (electric cook top)
A=650 min (gas cook top)
B=225 mm
C=260 mm
CONTROL PANEL
Delay switch: Canopy hood will remain on a
low, mid or high speed for five minutes to clear
away all residual cooking odours before
.
switching off automatically
Optional accessories
Charcoal filter
Light bulb
Chimney ext (10') SS
Chimney ext (12') SS
Chimney ext (10') IR
Recirculation kit
•
The canopy hood is designed for 2440mm
high ceilings.
•
The chimney is telescopic and is designed for
hood installations between 650 to 750mm
above the cooking surface.
•
Ascertain the desired installation height of the
canopy hood.
•
Any installation above 750mm
compromise the extraction performance.
•
The air outlet from the motor requires
150mm round ducting which requires 170mm
diameter hole in the ceiling.
I I I I I I
Fan On/Off Mid Speed High Speed Delay Switch
103821
104467
1740
1744
will
Light On/Off