Surface Mount Installation - Cooper Lighting TopTier LED Installation Instructions Manual

Installation Instructions - TopTier LED
INSTALLATION
Tools Required
Phillips bit screwdriver, electrical wiring tools, wet location
UL Listed wiring connectors, UL Listed wet location
junction box.
Alignment Guide (Parking Garage Installation)
Align quick mount plate to junction box by aligning arrows
with parking garage driving lanes (Figure 3). Direction of
arrows should be in line with direction of traffic.

Surface Mount Installation

1. Loosen (Do not remove) the two locking screws
(Figure 1). Pivot both locking hinges out to the left/right
sides until they stop.
2. Slide quick mount plate forward until the plate
disengages from the housing (Figure 2).
Quick Mount
Plate
Figure 1.
Slide Quick
Mount Plate
Figure 2.
2
COOPER LIGHTING SOLUTIONS
(2) Locking Screws
Top Cover
(2) Locking Hinges
IB500110EN Installation instructions
3. Unhook quick mount plate from the wire hinge
(Figure 3).
4. Install the quick mount plate onto a wet location
junction box (Supplied By Others) using the hardware
supplied (#8-32x3/4" or #6-32x3/4" screws). See
alignment guide above and the alignment arrows on the
quick mount plate label (Figure 3).
5. Hang the luminaire to the quick mount plate by the wire
hinge (Figure 4).
Alignment Guide Label
Align Arrows with Driving Lane
6861H01
Wire Hinge
Figure 3.
Figure 4.
Wet Location Junction Box
(Supplied by Others)
Quick Mount Plate
(2) Locking Hinges
Housing Plate
(2) Locking Screws
Retention Hooks
Wire Hinge