9.
Slide the drive into the drive bay, making sure to align the mounting screws with the mounting slots,
until the drive snaps into place.
10.
Connect the power cable (1) and data cable (2) to the rear of the optical drive.
11.
Connect the opposite end of the data cable to one of the light-blue SATA connectors on the system
board.
NOTE:
connectors.
12.
Replace the front bezel and computer access panel.
13.
Reconnect the power cord and any external devices, and then turn on the computer.
14.
Lock any security devices that were disengaged when the access panel was removed.
26
Chapter 2 Hardware upgrades
Refer to
System board connections on page 12
for an illustration of the system board drive