Plastic to Metal Shroud Conversion
All STS Impact (9PR, 9MS, 9LL) Exclude Lat Pull & Low Row Products
Notice:
Moving forward; Items: 2210-0002, 2210-0003, 2210-0004, 2210-0005, & 2210-0006 will be considered inactive
components that will not be available for purchase or warranty requests once stock is depleted. It is recommended that
any equipment requiring any of the previously mentioned parts is retro-fitted with sheet metal shrouds.
This document references all components required to retrofit equipment with the correct sheet metal shrouds and
outlines the procedure required to install a bracket conversion kit (PN: 731-5928-KT) on all Impact (9PR, 9MS, 9LL)
equipment that uses plastic weight stack shrouds; excluding the following products: Low Row (9xx-S3306) or Lat Pull
(9xx-S3305) machines.
Prior to commencing installation of the previously mentioned kit; verify that both the inner and outer weight stack
shrouds are readily available for installation with this kit.
Parts Required:
Bracket Conversion Kit (PN: 731-5928-KT)
•
Internal Metal Shroud (
•
External Metal Shroud (
•
Tools Required:
SAE Hex Key Wrench Set
•
SAE Open End Wrench Set
•
Screwdriver Set or Specific Drivers
•
Phillips Head Screwdriver
o
Instructions:
1. Impact Shroud Conversion – Plastic to Metal
STAR TRAC FITNESS
)
PN: See Last Page for Details
)
PN: See Last Page for Details
Part Replacement
Fig. 1
1 of 5
637-1524 Rev: A