Assembly - Weslo WLAW55072 User Manual

ASSEMBLY

Assembly requires two people. Place all parts of the AIR STRIDER in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Read through all steps before beginning assembly. As you assemble the AIR STRIDER, make sure that all parts
are oriented as shown in the drawings. Tighten all parts as you assemble them, unless instructed to do other-
wise. Refer to the drawings below to identify the small hardware used in assembly. Note: If a part is not found
in the parts bag, check to see if it has been pre-attached.
Assembly requires two adjustable wrenches
phillips screwdriver
M10 Flat Washer (39)Ñ4
Tree Fastener (32)Ñ2
M5 x 16mm Screw (23)Ñ10
1. Read all instructions at the top of this page
before you begin assembly.
Refer to the drawing at the right and identify the
Left and Right Uprights (1, 2). Note the location of
the stop rods.
Turn the Crossbar (10) so the Rocker Arm (9) is at
the top. Attach the Crossbar to the Left Upright (1)
with two M10 x 102mm Screws (44) and two M10
Flat Washers (39). Do not tighten the Screws
yet. Attach the Crossbar to the Right Upright (2) in
the same manner.
(not included).
Lock Washer (52)Ñ1
Plastic Spacer (41)Ñ2
M10 x 138mm Bolt (42)Ñ2
5
, a rubber mallet
3/8Ó Bushing (16)Ñ8
M10 Nylon Locknut (43)Ñ2
M10 x 102mm Screw (44)Ñ4
Fig. 1
Stop
Rods
1
39
44
, and a
3/8" Axle Cap (40)Ñ4
2
9
10