Table of Contents
Advertisement
Each RAID controller has a unique hardware Ethernet address, which is printed on a
label on the front. There is also a label giving the installation and expiration date of the
battery. The following illustration shows the location of these items.
For information about the RAID controller cache memory and rechargeable battery,
see "Cache memory and RAID controller battery" on page 34.
Adding a second RAID controller
Use the following procedure to install a second RAID controller if you have Model
3542-1RU storage server and have purchased the FAStT200 Redundant RAID
Controller option.
Note: The FAStT200 Redundant RAID Controller option comes with a RAID
1. To remove the RAID controller bay cover, use the following illustration and
52
IBM FAStT200 and FAStT200 HA Storage Servers Installation and User's Guide
Ethernet address label
Levers
controller cache battery installed.
procedure:
a. Push down on the latch (centered above the RAID controller bay cover). The
levers pop out of the locked position.
b. Grasp the pull-rings; then, pull on the levers and remove the RAID controller
bay cover.
Battery-access panel (on bottom)
Battery label
Raid controller
bay cover
Advertisement
Table of Contents
