Correct Setting:
When the tip of right needle is at 2 to 4 mm above the needle plate in its downward motion and
presser foot lowered, the top of the feed dog teeth should be level with the top surface of needle
plate at their rearmost position.
Before adjustment, check if the needle bar height and the feed dog height are correct.
To adjust:
1. Remove the free arm cover unit.
2. Set the stitch length dial at " 3 " and the differential feed dial at " 1.0 ".
3. Raise the presser foot and move the tip of right needle to 3 mm above the needle plate in its
downward motion by turning the handwheel.
4. Lower the presser foot, and loose two set screws A for feed cam.
# Turn the feed cam to the direction B if the feed dog is lower than the surface of the
needle plate.
# Turn the feed cam to the direction C if the feed dog is higher than the surface of the
needle plate.
5. Tighten two setscrews A.
6. Attach the free arm cover unit.
Setscrews A
B
C
TO ADJUST THE TIMING OF THE NEEDLE
AND THE FEED DOG
O. L G05
11
2 ~ 4 mm
2 mm