Correct Setting:
The distance between the surface of needle plate and bottom of presser foot should be 4.7 to 5.3
mm when the presser bar lifter is raised.
To adjust:
1. Remove the looper cover unit, top cover unit and front cover unit.
2. Raise the presser bar lifter, and loosen the setscrew A.
Then adjust the presser bar height, the side of presser foot should be parallel with the hole of
needle plate.
3. Tighten the setscrew A.
4. Attach the front cover unit, looper cover unit and top cover unit.
Top surface of needle plate
4.7 ~ 5.3 mm
TO ADJUST THE PRESSER BAR HElGHT
Presser bar lifter
O. L G05
9
Setscrew A
To be parallel
5 mm
(Direction of presser foot)
Needles