Fujitsu PRIMERGY TX150 S4 Options Manual page 37

Accessible drives
Figure 20: Installing the floppy disk drive in the drive holder
Ê Position the new floppy disk drive in the drive holder (1) and fasten it with two
screws on each side (2).
Figure 21: Mounting the floppy disk drive holder
Ê Push the drive holder and floppy disk drive fully into the mounting bay (1).
Fasten the drive holder to the housing with two screws.
Ê
Ê Connect the data cable to the floppy disk drive (see the cabling plans in the
Appendix).
Ê Connect the power cable to the floppy disk drive (see the cabling plans in the
Appendix).
Ê Attach the front cover or rack front cover, close the server, connect it to the
power outlet, and switch it on as described in the
page 67 et seqq..
U41629-J-Z156-2-76
Installing a 3.5-inch floppy disk drive
1
2
Options Guide
2
1
2
chapter "Completion" on
37