Weider WESY09321 User Manual page 9

13. Orient the Seat (13) and the Seat Carriage (12)
as shown. Attach the Seat to the Seat Carriage
with four M6 x 16mm Screws (82).
14. Set the Seat Carriage (12) on the Bench Frame
(5).
Slide a Steel Tube (57) into a Long Spacer (46).
Orient two Small Wheels (47) as shown in the
inset drawing, and slide them onto the ends of the
Steel Tube.
Have one person press the Seat (13) against the
Bench Frame (5). Press the wheel assembly tight
against the bottom of the Bench Frame and attach
it to the lowest set of holes in the Seat Carriage
(12) with an M8 x 79mm Bolt (60) and an M8
Flange Nut (84). Do not overtighten the
Locknut; the Small Wheels (47) must be able to
roll easily.
Slide the Seat Pin (45) through the Seat Carriage
(12) and an adjustment hole in the Bench Frame
(5).
15. Press two 25mm Square Inner Caps (54) into the
indicated ends of the Backrest Frame (15). Press
the Backrest Cap (16) onto the other end of the
Backrest Frame.
Attach a Plastic Foot (53) to the Backrest Frame
(15) with an M4 x 16mm Screw (56).
Attach the two Guard Plates (17) to the inside of
the Bench Frame (15) with four M4 x 16mm
Screws (56).
16. Orient the Backrest (14) as shown. Attach the
Backrest to the Backrest Frame (15) with four M6
x 38mm Screws (58) and four M6 Washers (77).
13
12
14
Adjustment
Small
57 46
Side
47
Large Side
15
16
16
77
9
13
82
82
60
13
84
12
5
Hole
47
47
46
57
47
15
53
56
56
17
56
17
14
15
77
58
77
58
45
54