Weider WESY09321 User Manual page 12

24. Slide an end of the Long Cable (80) through the
Pulley Arm (22). Wrap the Cable around a 90mm
Pulley (28). Attach the Pulley to the Pulley Arm
with an M10 x 40mm Bolt (71) and an M10 Nylon
Locknut (76).
25. Locate the Bench Cable (32). It has three ends,
two that are the same length and a third that is
longer.
Route the long end of the Bench Cable (32)
through the hole in the Front Leg (6), and attach it
inside the hole in the Leg Lever (7) with an M10 x
60mm Bolt (63), two M10 Washers (75), and an
M10 Nylon Locknut (76).
26. Attach a 90mm Pulley (28) inside the hole in the
Front Leg (6) with an M10 x 66 mm Bolt (79), two
12.5mm Spacers (52), two M10 Washers (75),
and an M10 Nylon Locknut (76). Be sure the
Pulley is over the Bench Cable (32).
Slide the two free ends of the Bench Cable (32)
onto the eyebolt welded to the bottom of the
Bench Frame (5).
27. Locate the two Short Cables (33). Wrap a Short
Cable around a 90mm Pulley (28). Attach the
Pulley to a Pulley Housing (21) with an M10 x
40mm Bolt (71) and an M10 Nylon Locknut (76).
Repeat this step with the other Short Cable
(33).
24
25
26
32
Eyebolt
27
76
12
71
80
28
76
63
32
6
7
76
75
5
75
52
28
75
52
76
21
71
28
33
75
79