NEC Express5800 SIGMABLABE User Manual page 57

Description
■ N8406-051F
1 1
Name
1. ID LED
2. STATUS LED
3. Ejector
4. Serial Port
5. Uplink port
(SFP+ module slot)
6. Uplink port
(QSFP+ module slot)
7. LINK LED
8. ACT LED
9 LINK/ACT LED
10. RESET Switch
NOTE: The Switch Module works with the Blade Enclosure. It does not
have a POWER switch.
3 3
-38- -38- -39- -39- -40- -40-
2 2 4 4
The LED is intended to identify the Switch Module in the Blade Enclosure. The LED is lit
by software command.
Indicates the Switch Module status.
Contact your service representative if it does not go on green in five minutes after the
Blade Enclosure is powered on.
Use this lever to install or remove a Switch Module in/from the Blade Enclosure.
Not available
SFP+ module connectors for optional fiber uplink or optional copper uplink
Not available
Indicate the link status of each LAN port.
Off
On (Green)
Indicate the activity of each LAN port.
Flash (Green)
Not blink
Press this switch to restart the Switch Module.
Pressing the RESET switch reboots this Switch Module, loses the configuration
data not to save in the flash memory, and temporarily disconnects
communication with the network.
7 8 7 8
-41- -41-
-42- -42- -43- -43- -44- -44-
5 5
Description
Link not established
Link established
Data being transmitted or received
6 6
N8406-051F N8406-051F
-45- -45-
RST RST
50-53 50-53
46-49 46-49
9 9
(English)
10 10
47