Weider Pro 4850 831.153932 User Manual page 14

29. Wrap the Lat Cable (88) around a 90mm Pulley
(78). Attach the Pulley and a Long Cable Trap (102)
to the Top Frame (6) with an M10 x 50mm Bolt
(100) and an M10 Nylon Locknut (87). Make sure
the Cable Trap is turned to hold the Cable in the
groove of the Pulley.
30. Remove the preattached 90mm Pulleys (78)
from the Pulley Plates (63).
Wrap the Lat Cable (88) around a 90mm Pulley
(78). Attach the Pulley and a Cable Trap (68) to the
second set of holes from the top of the Pulley
Plates (63) with an M10 x 50mm Bolt (100) and an
M10 Nylon Locknut (87). Make sure the Cable
Trap is turned to hold the Cable in the groove of
the Pulley.
31. Attach the end of the Lat Cable (88) inside of the
Butterfly Top Frame (7) with an M10 x 67mm Bolt
(121), two M10 Washers (91), and an M10 Nylon
Locknut (87).
32. Locate the Butterfly Cable (69), which is the
shortest Cable. Attach the Cable to the Pivot
Bracket (70) on the Left Butterfly Arm (25) with an
M8 x 25mm Shoulder Bolt (103) and an M8 Nylon
Locknut (86).
33. Wrap the Butterfly Cable (69) over a "V"-pulley (55).
Attach the Pulley and a Long Cable Trap (102) to
the indicated bracket on the Butterfly Upright (3)
with an M10 x 60mm Bolt (18) and an M10 Nylon
Locknut (87). Make sure that the Long Cable
Trap is turned to hold the Cable in the groove of
the Pulley.
29
30
87
31
32
33
14
88
78
87
102
100
6
100
68
78
87
88
63
91
91
121
7
88
86
69
103
70
25
3
87
55
102
18
69